What is hub puller?
The wheel hub puller is a set of tools used to remove the wheel hub from the axle without damaging the hub. It consists of a yoke or adapter, a pressure screw, a slide hammer, and lug nuts.
What tools are needed to change wheel bearings?
What Tools Do I Need To Replace A Wheel Bearing?
- A set of needle-nosed pliers.
- ratchet wrench with various sized sockets.
- flat-head screwdriver.
- jack.
- star wrench for loosening nuts on the wheel.
How do you remove a rear axle bearing without a puller?
Steps to take if you want to know how to remove bearing from the shaft without a puller
- Apply the vehicle’s parking brake.
- Use a car jack to raise your vehicle.
- Place jack stands under your vehicle.
- Remove the tires.
- Unbolt the caliper and remove the Brake pads from it.
- Remove the vehicle’s disk rotor.
What tools are needed to change a wheel bearing?
Wheel bearing assembly
How do you repair a wheel bearing?
Slide hammer
When and how to service your wheel bearings?
Multi-sized cone spanners: 13,14,15 and 16mm
Do you need special tool to change wheel bearings?
Many require special tools that should be used to avoid damaging other parts of the vehicle. Seriously, the wheel bearing puller tool will make this job much simpler. As you remove the wheel bearing, be cognizant of the axle and avoid letting it drop, get dirty, or put stress on any other parts. Clean off any corrosion found on the involved parts.