What is Hilti RE 500 used for?
Hilti HIT-RE 500 V3 adhesive anchoring system can be used for post-installed rebar and threaded rod installations for anchor design in accordance with ACI 318-14 Chapter 17 and CSA A23.
Are chemical anchors strong?
Chemical anchors (I prefer the simpler term ‘resin anchors’) exert no setting stresses in the base material so can be specified at closer edge and spacing distances in concrete and will usually develop the strongest anchorage in masonry materials – which are their main ‘Pros’.
How long does Hilti 500 take to cure?
Hilti HIT-RE 500 V3 gives you a 25-minute working time at 72o with initial cure in four hours and full cure in six hours. Use Hilti Adhesive Anchor products with diamond-coring methods.
Can chemical anchors be removed?
Usually, a screwdriver, pipe wrench, or vise grips can unthread the protruding bolt, leaving the female anchor flush with the concrete. If needed, a hammer can be used to knock the anchoring tube below the floor, and in some cases these tubes can simply be pulled out of the hole entirely.
How do I get rid of Hilti anchors?
The only way to remove one without damaging the base material is by cutting off the head of the anchor. This can be done with a saw or cutoff wheel.
When would you use a chemical anchor?
Chemical anchors —also known as chemical studs—can also be placed towards the edge of concrete substrates and through masonry block. The non-expanding nature of a chemically-held rod drastically reduces the chance of the surrounding concrete cracking.
What is Hilti chemical?
Hilti Chemical Anchoring ₹ 1,500/ Each Get Latest Price. Brand: Hilti. A wide range of chemical anchor fasteners – our injectable mortars are also designed for rebar applications and can be used on concrete and masonry.
Can the Hilti hit-re 500 anchor be loaded?
the anchor can be loaded. The applied installation torque shall not exceed T max Setting instructions page 178 February 2014 Hilti HIT-RE 500 with HIT-V / HAS in diamond drilled holes Data according ETA-04/0027, issue 2013-06-26 Additional Hilti technical data Anchor size M8 M10 M12 M16 M20 M24 M30 M36 Nominal diameter of drill bit d
What is Hilti hit adhesive mortar?
Injection of Hilti HIT adhesive mortar for fastening anchor rods and rebar in concrete and masonry For use together with a 500 ml black or red cartridge holder
What is the anchor size of Hilti h-h 200?
page 108 February 2014 Hilti H-H 200 with H-()N N* V* S1 C h Two anchors Table 1: One edge influence – non cracked concrete Design Data: fc=32 MPa Anchor size M8 M10 M12 M16 M20 Min Slab depth120 150 200 250 300 Embedment Depth90 110 125 170 205 ANCHOR M8 Edge C (mm) 40 80 100 150 200
How to optimise anchor design using Hilti PROFIS?
The latest version of the Hilti software Profis allows the engineer to optimise their design by varying the embedment depth according to the applied loads to achieve an economical solution every time. This is done by selecting rebar. The anchor design software program Profis can be download from the Hilti Australia website, www.hilti.com.au.