Is an 8 in jointer enough?

Table of Contents

* Get an 8″ jointer if you want the capability to face-joint boards up to 8″ wide. * With infeed and outfeed tables each measuring 10–18″ longer than those on a typical 6″ model, an 8″ jointer helps you more accurately joint longer workpieces without adding support.

What is the maximum depth cut for a jointer?

1/16”
The maximum depth of cut is 1/16”; never force, or over feed the jointer by taking too thick of a cut. Final passes should be no more than 1/32”. Depth of cut is adjusted by raising or lowering the in-feed table.

How much does a Delta 8 jointer weigh?

Weight: 335 lbs.

What is the best jointer to buy?

The Best Jointer For Every Type Of Woodworking

PORTER-CABLE Benchtop Jointer.
CRAFTSMAN 10-Amp Benchtop Jointer.
Delta Midi-Bench Jointer.
Wahuda Tools Jointer.
Wolfcraft 2920000 Multi Wood Jointer.
WEN 10-Amp Corded Benchtop Jointer.

How much does a Delta jointer weigh?

DELTA’s 6″ professional jointer makes it easy with a 1 HP motor, rack and pinion fence system, three-knife cutterhead and easy-to-position infeed table. Weight: 225 lbs.

Is a 6 jointer good enough?

“I found my 6 inch jointer was almost useless. Top quality hardwood must finish to 6 inches wide to earn the FAS grade, which means that it must start at least 6 1/2 inches wide, which means even the narrowest boards won’t fit on a 6 inch jointer.

What is the best Delta jointer for 8 inch boards?

This jointer has been replaced by Delta’s model 37-365X, which sells for about $1,900. Excellent cut quality and power made the 37-350A one of the top contenders in our test of eight 8″ jointers. Its 43-1/2″ long infeed table provides great support for long boards, while keeping the overall bed length manageable at a little more than 72″.

Is the Delta 37-350a a good jointer?

What size joiner do I need for Rockwell Delta?

SAFETY SUGGESTIONS FOR ROCKWELL DELTA JOINTERS 6″ JOINTER 6″ DELUXE LONG-BED JOINTER IF YOU ARE NOT thoroughly familiar with the operation of Jointers, obtain advice from your supervisor or instructor. REMOVE tie, rings, watch and other jewelry, and roll up sleeves.

What kind of motor does Delta have in a DJ 20?

Delta Industrial Model 37-350 DJ-20 8″ Precision Jointer with 1 1/2HP, 120/240V, 60 Hz., single phase motor a Model No.37-355 set of 3 HSS knives, cutterhead module, cutterhead guard, with wrenches, rabbeting ledge, tilting fence, push blocks and two pulleys.