Can you remove a concrete hearth?

Instead of a hammer and chisel, you’ll need to use a sledgehammer to break up the concrete. Alternatively, you can use an SDS rotary drill and an SDS chisel. Due to the nature of concrete, you’ll have to break up the concrete hearth into pieces and remove them bit by bit.

Can a fireplace hearth be removed?

Fortunately, hearth removal is a simple process. Once the surrounding floor has been protected, the hammer and chisel are used to chip away at the hearth until it has been removed.

How do you clean a concrete slab in front of a fireplace?

Cleaning Concrete Fireplaces With sealed concrete, you’ll want to use 1 gallon of hot water with 1/4 cup of dish soap. Scrub the mantel or hearth with a scrub brush using this solution and then follow with a scrub using hot water to rinse out the soap. Allow the concrete to dry completely.

Can a brick fireplace hearth be removed?

Remove the bricks at the surface of the hearth by chipping them up with the rotary hammer and chisel-bit. Remove the remaining rows of bricks and mortar that comprise the outer edges of the hearth. Chip out and remove the mortar-bed at the floor to expose the wire lath. Avoid digging into the subfloor.

Can you remove a raised hearth?

Remove Old Hearth Use demolition hammer with a chisel bit to chip away old hearth and the mortar underneath (as shown). Leave concrete hearth base and firebox floor in tact. Brush and vacuum debris and dust from hearth base. Tip: Wear eye and ear protection and a dist mask when using a demolition hammer.

Can I tile over brick fireplace?

Can you tile over a brick fireplace? Yes! Tiling over brick (even painted bricked!) is an easy DIY project as long as your brick is in good condition.

How do you remove a cement mantle from a brick fireplace?

How to Remove a Mantel From a Brick Wall

1. Remove any decorative trim around the outside edges of the mantel.
2. Insert the short end of an I-beam construction pry bar between the back edge of the mantel and a brick wall.
3. Cut through the mounts with a reciprocating saw to release the mantel.

How do you clean a dirty hearth?

Start by saturating the brick with water. Scrub with soapy water, using a clear soap or one labeled for use on brick. Scrub with a fiber or plastic-bristle brush, not one with metal bristles. Then rinse several times, using the masonry sponge.

How to make a polished concrete fireplace Harth?

Gather Your Supplies. Even though the Pollios were covering a large surface area,their supplies were fairly limited.

Install the Durock and Corner Bead. Because the Pollios didn’t have existing drywall or a mantel to work around,they went straight for the Durock—cement boards that are

Apply the Ardex to the Joints.

Skim Coat the Entire Surface.

How to reface a fireplace with concrete?

Brush the concrete bonding agent onto the bricks,this will help the stucco adhere to the brick. Allow it to dry at least 30 minutes.

Either purchase ready-made stucco,or mix concrete and sand together to make your own.

With a notched trowel,run a series of grooves in the first coat of stucco.

How to stain a concrete fireplace?

– Test your concrete fireplace to make sure it accepts the stain. – Place a plastic drop cloth around your concrete fireplace and put a cloth drop cloth on top of it. – Remove any dirt or debris from the concrete fireplace, and then use a sponge to wash the concrete fireplace with soap and water.

How to remove tile from a fireplace hearth?

Removing a tile fireplace surround provides you with a blank slate to upgrade your fireplace wall any way you like. Advertisement Video of the Day Step 1 Place the tip of a flat-head screwdriver over a portion of the tile’s grout. Tap lightly on the screwdriver’s handle with a rubber mallet. The grout will crack.