Who makes eternal water heaters?
Grand Hall
The Eternal is manufactured in Taiwan by Grand Hall. It has a 20 year warranty compared to a 15 year like most other tankless manufactures.
What temperature should tankless hot water heater be set to?
You’ll want to shoot for 100-115 degrees Fahrenheit for your water to be heated. If your groundwater temperature is 60 degrees and you want your shower at 110 degrees, that’s going to be a 50-degree rise.
How do I reset my Rheem error code?
How Do I Reset My Tankless Water Heater?
- Head to the electric panel and locate the water heater circuit.
- Remove the panel cover and locate the reset button behind the insulation.
- Press it inwards until it clicks in place and then releases.
- Replace the panel cover.
- If the gas valve was disconnected, reconnect it.
How do I reset my Rinnai water heater?
Turn off all hot water faucets/taps. Press On/Off button twice. Turn hot water back on and test. You may have to try this a couple times to reset the system.
What happened to Eternal water heater?
After a year of trying to correct the problems, Grand Hall, the parent company of Eternal Water Heaters, ceased operations in North America leaving their customers without warranty coverage, part replacements and technical resources. Hot Water Now!
Why does my tankless water heater run out of hot water?
One of the primary reasons your tankless system might stop producing hot water is because it’s being overwhelmed by the demand. This can happen if there are several hot water appliances in use at the same time. For example, if you run a bath, a clothes washer, a dishwasher, and a shower at once.
Why am I not getting hot water from my Rheem tankless water heater?
The Air Supply or Exhaust Is Blocked At times, your exhaust or air supply might get blocked, which can cause your tankless water heater to stop heating. Many water heaters will automatically shut off as a way to protect the appliance and help prevent other safety hazards that could result.
How do I get a Rinnai error code?
To display error codes, press the ON/OFF button followed by the thermostat button to cycle through the error codes. 2. To display the water flow through the water heater, press the thermostat button (hold for 2 seconds) and then press the ON/OFF button while continuing to hold the thermostat button.
How do you clear a Rinnai error code?
After flushing water heater, the procedure to reset LC codes: Push the two switches (A and B) on PC Board at the same time for five seconds. Water heater will return to normal operation and LC# count returns to 0. This hard reset procedure is not in owners/installation manual or tech sheet.
What is the license number for eternal tankless water heaters?
Is licensed and insured. Our Colorado plumbing license number is PC.0003145 . To assist with diagnosing an error, Eternal tankless water heaters have the ability to check their own operation continuously. If an error occurs, a message will flash on the digital monitor of the front panel.
What happened to the eternal heat exchanger in 2014?
In 2014 increasing problems with the Eternal heat exchanger and controls resulted in leaks and premature system failures.
What happened to eternal water heaters?
After a year of trying to correct the problems, Grand Hall, the parent company of Eternal Water Heaters, ceased operations in North America leaving their customers without warranty coverage, part replacements and technical resources. You may be able to clear the Error Message simply by turning the hot water tap OFF, then ON again.