What does it mean when your washer says F51?
The F51 error may indicate there is a MOTOR ROTOR POSITION SENSOR FAILURE (RPS). The sensor and control board has a connection or fault issue. This error can be cleared by cleaning/reconnecting the sensor OR replacing it.
What does F mean on Whirlpool Cabrio washer?
An F/dL error code indicates a problem with the door lock. The error code will pop up when the door fails to lock. The washer will display the error code after six attempts to lock the door. To fix the issue, the door lock assembly needs to be inspected for loose or broken wires and other signs of damage.
How do I force my Whirlpool Cabrio washer to drain?
Find the “Pause/Cancel” button on the control panel. Press this button twice to drain the washer. Press the “Power” button and rotate the cycle selection knob to “Drain and Spin” to remove the remaining water from the load. Check the washer’s discharge hose if the water fails to drain from the washtub.
How do you reset the sensor on a Whirlpool Cabrio washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
How do I fix error F51 on Whirlpool Cabrio?
The first step is to reset your washer. Sometimes simply resetting the washer will remove the F51 error code; this is because it allows the capacitors of the control board to discharge and then start to work correctly again. To reset the washer: Try to reset the washer by pressing down the “Pause/Cancel” button.
What is rotor position sensor?
The high-speed rotor position sensor measures the angular position of the rotor shaft in synchronous electric motors. The sensor signal is required for driving the e-machine torque control used in electric and hybrid vehicles.
How do you troubleshoot a Whirlpool Cabrio washer?
Clean all contact areas on the lid and the washer. Try unplugging the washer to allow the control panel to reset. Plug the washer back in and see if the problem resolves. If the door sounds like it is engaging, but doesn’t, it is time to run a diagnostic test.
How do I fix error code F51 on Whirlpool Cabrio washer?
Sometimes the Whirlpool Cabrio washer shows the F51 error code when it has a faulty RPS. Fix this problem by replacing the rotor positioning sensor. The RPS is situated on the left side of your washer’s three engine harnesses.
How to fix the F51 error code in Windows 10?
How to fix the F51 Error? To begin with, try rebooting your device, as it could be just a short system glitch that provoked the error code indication. Switch the machine off and unplug it for 10-15 minutes, then switch it back and see whether the F51 code is still detected. If it is, proceed with the drum.
Why does my Kenmore washer have a fault code of F51?
Therefore, the drum loses its capacity to rotate uniformly, causing friction in the washer’s drive system and leading to the appearance of fault code F51 o the washer’s digital display screen. Follow this process to identify the problem: Manually spin your washer’s drum and inspect the quality of rotation